Xerox WorkCentre 7132 User Manual page 407

Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
Code
016-717 A [Transmission Report - Undelivered] or [Activity Report] was requested, but
the the required transmission result information is not stored in memory, and the
report was not generated. Take one of the following actions:
• Partition memory intensive jobs (iFax) to limit the memory and the hard disk
use.
• Execute any pending scan and iFax jobs after other scan and iFax jobs are
finished.
• Request the report before 200 or more subsequent jobs have been executed.
016-718 Unable to process PCL print data due to insufficient memory. Take one of the
following actions:
• Lower the resolution.
• Use no multiple-up or 2 sided print feature, and try printing again.
016-719 Unable to process PCL print data due to insufficient print page buffer memory.
Increase the print page buffer.
016-720 PCL print data contained a command that could not be processed. Check the
print data, and then try printing again.
016-721 An error occurred while printing a job. The Auto Tray Switching feature was
enabled when [Auto Paper Off] is selected for all paper trays on the [Paper Type
Priority] screen. When the Auto Tray Switching feature is enabled, select a
paper type other than [Auto Paper Off] on the [Paper Type Priority] screen.
016-722 The specified stapling position is not supported. Check the staple position, and
try printing again.
016-723 The specified punch position is not supported. Check the punch position, and try
printing again.
016-724 The combination of specified staple and punch options was imcompatible.
Specify punch and staple position along the same edge of the paper and try
printing again.
016-725 A scanned document saved in a mailbox could not be converted to fax data
during transmission processing using the job flow sheet. Do not use the job flow
sheet. Instead scan the document, and send the fax directly.
016-726 The printer language cannot be automatically selected when the print mode is
set to [Auto], including:
• PostScript data was sent without the PostScript Kit installed. Install the
PostScript Kit.
• A PDF file is sent directly to the machine, but unable to process the job. THe
hard disk drive may not be installed properly on the machine or may be
damaged. Contact the Xerox Welcome Center.
• HP-GL/2 or PCL data is sent to the machine without the optional emulation
kit. Install the emulation kit.
016-727 The result of a print request is a zero-page document that cannot be stored in a
mailbox, and the job is canceled. Set the print option to print blank pages, and
reprint to confirm if the output is not blank. Add text if the output is blank, and try
printing again.
Description and Remedy
Fault Codes
407