Xerox WorkCentre 7132 User Manual page 263
Hide thumbs
Also See for WorkCentre 7132:
- Service documentation (1726 pages) ,
- User manual (468 pages) ,
- System administration manual (184 pages)
Table of Contents
Advertisement
Receiving Buffer - IPP Spool
Receiving Buffer - EtherTalk
Receiving Buffer - Port 9100
Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
NOTE: When printing with the receiving buffer spooling set to [Memory] or [Hard
Disk], each page within a job is printed in the sequence assigned by the operating
system. However, somethimes pages between different jobs may not be printed in the
intended sequence if, for example, printing multiple copies of a single 1-page job. In
this case, set spooling to [Off], the default, to maintain the intended printing sequence.
Off
Specifies no spooling. Allows you to change the input buffer memory capacity within
the range of 64-1,024 KB in 32 KB increments using the scroll buttons or the numeric
keypad.
Memory
Specifies spooling to memory. Allows you to change the input buffer memory capacity
within the range of 0.50-32.00 MB in 0.25 MB increments using the scroll buttons or the
numeric keypad.
Hard Disk
Specifies spooling to the hard disk.
Specifies the input buffer memory capacity for the IPP interface. The currently available
memory will be displayed at the top of the screen with the following message: "Memory
Available: XXX MB."
NOTE: When printing with the receiving buffer spooling set to [Memory] or [Hard
Disk], each page within a job is printed in the sequence assigned by the operating
system. However, somethimes pages between different jobs may not be printed in the
intended sequence if, for example, printing multiple copies of a single 1-page job. In
this case, set spooling to [Off], the default, to maintain the intended printing sequence.
Off
Specifies no spooling. Allows you to change the input buffer memory capacity within
the range of 64-1,024 KB in 32 KB increments using the scroll buttons or the numeric
keypad.
Hard Disk
Specifies spooling to the hard disk.
Specifies the input buffer memory capacity for Ethertalk interface within the range of
1024-2048 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
currently available memory will be displayed at the top of the screen with the following
message: "Memory Available: XXX MB."
Specifies the input buffer memory capacity for Port 9100 interface within the range of
64-1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
Print Mode Settings
263
Advertisement
Table of Contents
