Other Settings - Xerox WorkCentre 7132 User Manual
Hide thumbs
Also See for WorkCentre 7132:
- Service documentation (1726 pages) ,
- User manual (468 pages) ,
- System administration manual (184 pages)
Table of Contents
Advertisement
Initialize Hard Disk
Delete All Data
Software Options
Document Feeder Scanning Position
Other Settings
Offset Stacking (Center Output Tray )
Offset Stacking (Finisher Tray)
Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
This feature allows you to initialize the hard disk on the machine. After selecting
[Initialize Hard Disk], select a partition, and then select [Start]. Then select [Yes] to
execute initialization. After the initialization finishes, select [Confirm].
NOTE: This process may take a while depending on the machine configuration.
This feature allows you to delete all document data on the machine. Select [Delete All
Data], and then select [Start]. Then select [Yes] to execute deletion. After the deletion
finishes, you need to switch the machine off and then on.
NOTE: This process may take a few hours depending on the machine configuration.
Specifies software options. For information on setting procedures and software codes,
refer to the instructions for the required software option package. Enter passwords for
the software options using the keyboard screen and select [Reboot].
This feature allows you to adjust the scanning position of the document feeder precisely
in the range in 0.1mm (0.004 inch) increments. Select [Factory Settings] to restore the
default settings.
This feature allows you to configure various other settings common to the main features
such as copy, fax, and scan.
1.
Select [Other Settings] on the
[Common Settings] screen.
2.
Change the required settings.
Use the side tabs to switch
between screens.
3.
Select [Close].
Specifies the output paper stacking position for the Center Output Tray. When printing,
the machine can slightly offset the paper output positions for each set (copies) or job
(individually instructed print job). This allows you to identify the start of each set or job.
Specifies the output paper stacking position for the Finisher Tray. When printing, the
machine can slightly offset paper output positions for each set (copies) or job
(individually instructed print job). This allows you to identify the start of each set or job.
Common Settings
233
Advertisement
Table of Contents
