Paper Jams In Cover A - Xerox WorkCentre 7132 User Manual

15 Problem Solving

Paper Jams in Cover A

384
Downloaded From ManualsPrinter.com Manuals
Paper Jams in the Duplex Module Cover D – page 389
Paper Jams in the Office Finisher (Optional) – page 390
Paper Jams in the Integrated Office Finisher (Optional) – page 391
Media jams happen for a variety of reasons. Check the guidelines below to reduce
potential jams in the machine.
• Use only recommended media. Refer to Supported Paper Sizes in the Paper and
Other Media chapter on page 213 and Machine Specifications in the Specifications
chapter on page 433 for a list of recommended media types.
• Protect unused media by storing it in its wrapper, on a flat surface.
• The orientation of the media in the paper tray must match the orientation of the
documents.
• Check the maximum fill line in the tray to make sure the paper tray is not overloaded.
• Do not use media that is torn, wrinkled, or folded.
Follow the steps below to clear paper jams in Cover A. Follow the messages on the
touch screen and remove jammed paper from the specified location.
CAUTION: The left-hand cover should not be opened while the machine is operating.
If the left-hand cover is opened, the machine automatically stops. Push firmly to close
the cover, as it may become difficult to close. Follow the message on the screen, if
present, to remove any paper jammed in the machine.
1.
Open the bypass tray, and then
open Cover A while lifting up the
release lever.
NOTE: Remove the paper from the
side tray before opening Cover A.
2.
If the jammed paper extends
from behind the fuser unit, rotate
the lever on the right-hand side
in the direction of the arrow to
feed the paper.
Xerox WorkCentre 7132 User Guide