8.4 Charge Cleaner Drive Wire Replacement
1. Remove the corona wires. (Refer to "Charge Corona Wire Replacement.")
2. Remove the drive wire tension springs [A], drive gear [B], and the old drive wire [C].
3. Wrap the new wire around the drive pulley one and one-half times [D].
4. Place the drive ring [E] over the post of the wire cleaner [F].
5. Slip the wire over the idle pulley [G].
6. Install the wire.
7. Reassemble the corona unit.
NOTE: Make sure that the corona wire is positioned between the cleaner pads. Also, check
the wire cleaner movement using SP-7.
Make sure that the spring that acts upon the home position sensor actuator is seated
correctly.
5-63
31 August 1989