Printing On Custom Size Or Long-Size Paper; Loading Custom Size Or Long Size Paper; Using The Bypass Tray - Fuji Xerox DocuPrint 3105 User Manual

3.3 Printing on Custom Size or Long-size
Paper
This section explains how to print on long-size and custom size paper.
The following are the sizes of paper that can be loaded into the paper trays.
* The long size of 900x297mm can be used.

Loading Custom Size or Long Size Paper

Using the Bypass Tray

The following example explains how to load long-size paper into the bypass tray.
Note
• Finger prints can leave marks on the printing surface of long-size paper. Take care to avoid getting
marks on the long size paper when loading it.
• For information about loading other custom size paper, refer to "4.2 Loading Paper" (P. 107).
• The only paper type setting that can be specified for long size paper is [Custom (297 - 900 mm)].
1. Load the paper into the bypass tray with the
print side of the long-size paper facing up
and the trailing edge curled as shown in the
illustration.
Note
• Curl the trailing edge of the long-size paper as far as
possible from the paper inlet slot. Curling it too close
to the paper inlet slot can result in the trailing edge
feeding into the printer, causing the paper to be
creased or wrinkled.
• Carefully insert the leading edge of the paper into the
inlet slot of the bypass tray. Incorrect insertion can
cause paper jams.
• Load paper one sheet at a time.
2. Adjust the paper guide to the size of the
long-size paper.
Since long-size paper is long, be sure to
pick up each printed sheet as it comes out
to avoid it from falling to the floor.
66
3 Printing
Bypass Tray
Paper feed direction
Length:
98 - 432 mm
Width:
75 - 297 mm
Trays 1 - 3
Paper feed direction
Length:
148 - 432 mm
Width:
76 - 297 mm