Using The Touch Panel Controller; Tpc Power-Up Defaults; Failed Tpc Connection - Christie CP2000 User Manual

BASIC OPERATION
TPC Power-Up Defaults 
Failed TPC Connection 
3.5 Using the
Touch Panel
Controller
3-10
rights, extent of data logging. An installer can see ID and error information for
servers, as well as a detailed diagnostics log for in-depth troubleshooting.
When the CP2000 powers up (see 3.2, Power-up Procedure), the Touch Panel
Controller will begin the steps of Initializing..., Attempting to log on..., and
Updating status, displaying its progress on the TPC status bar at the bottom of the
screen. When initializing is complete, all files are refreshed on the TPC and the
system is in a ready-to-use default operating mode:
•
The Main menu appears on the Touch Panel Controller, where you can press
the lamp button to turn on the lamp.
•
The most recently used display button is depressed (darkened). Upon turning
on the lamp, the image will appear.
If the TPC fails to initialize and instead displays a communication error such as No
connection or Cannot locate Ethernet port or Waiting to Connect, there is likely a
bad connection or address between the TPC and the rest of the projector. Check that
TPC cabling is intact, and try again. Review Section 7, Troubleshooting and, if the
problem persists, contact your network administrator.
Touch Panel Controller software resembles other Windows-based applications, but
is activated by touching the TPC screen itself.
•
Touch large "raised" rectangular buttons to activate a function such as turning
the lamp or shutter on or off, or to start a presentation, or select a different
icon. Buttons may include text and/or an icon.
•
To log on/off as a different user, touch the user icon in the bottom right corner.
•
To go to a new menu, touch its tab at the top of the page.
•
To go to a submenu, touch its tab located above the status bar.
•
To see more options in pull-down menus, touch
•
To select an option in a list, touch the option text.
•
To begin entering text such as serial numbers, touch the entry box.
•
To "escape" without change from a pull-down list, touch menu background.
•
Leaving a menu automatically saves its current settings.
•
Touch checkboxes to toggle on or off.
•
Touch to jump to the Status menu at any time.
All TPC menus and functions are illustrated and explained below.
NOTES: 1) Shown are SAMPLE menus only—your specific text and/or icons may
vary according to settings recorded in the password-protected menus. By default, the
Main menu offers 32 pre-configured channels (buttons). This may have been changed
during installation at your site—consult the default setup card provided with your
projector. 2) If necessary, adjust TPC screen brightness and contrast via the
Windows CE Display Settings for this device (service password required). If your
TPC is enclosed in a blue casing, use the small knob on the back of the unit to adjust
screen settings.
.
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)