Table of Contents
Advertisement
1. On the touch panel controller, tap Menu > Lamp LampLOC and adjust the lamp
position manually.
2. Observe screen brightness by adjusting the X, Y and Z values or use a light meter to
check for changes in brightness.
•
Make sure that the anode yoke is in the correct location.
•
Check that the flat part of the anode end of the lamp (if applicable) faces up in the anode
yoke.
Touch panel controller is blank
The projector is powered on but the touch panel controller (TPC) is blank.
Details
The touch panel controller is a touch-sensitive screen used to control the projector, manage sources,
adjust the display, and view status information.
Resolution
•
If the touch panel controller display is blank, make sure the touch panel controller
communication harness is connected securely.
Blank screen, no display of image
The projector is powered on but the screen is blank and no image is displayed.
Resolution
•
Make sure both lens caps have been removed from the projection lens.
•
Make sure the lamp is on.
•
Make sure that all power connections are good.
•
Make sure the shutter is fully open.
•
Make sure that any test pattern (other than a full black test pattern or test pattern = none)
displays properly.
Cannot communicate with the projector
The remote computer or server cannot establish communication with the projector.
Resolution
•
Make sure the computer and the projector are both connected to the network.
•
Make sure that all input devices have the same subnet mask and unique IP addresses.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Troubleshooting
33
Advertisement
Table of Contents
