Secure Bulb At Cathode And Anode Connectors - Christie CP2000 User Manual

STEP 9 
STEP 10 
STEP 11 
STEP 12 
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)
8.3. Tighten set screws in both negative and positive lamp connectors (Figure 6.2).
Figure 6.2. Secure bulb at cathode (–) and anode (+) connectors
IMPORTANT: Proper electrical contact prevents resistance in the lamp connectors.
If you accidentally touch the quartz body of the lamp with your bare hands, clean it
as described in 6.3, Maintenance and Cleaning.
Check Leads
Make sure that the anode (+) lead between lamp and igniter is well away from any
projector metal such as the reflector or firewall.
Leads too close to metal parts will cause arcing during
starting pulse. This is a SAFETY HAZARD,
Close cooling compartment and lamp door
The projector will not operate unless the louvered door is locked shut.
Turn breakers to ON
At the projector's breaker panel, turn all breakers to
Set proper LAMP TYPE (power)
NOTE: Skip this step if your new lamp is the same size as the old lamp—the Lamp
Type will still be correct in the Install menu.
IMPORTANT: Requires access to TPC "Installer" menu.
If your new lamp is larger or smaller than the old lamp, record the new lamp type
(2.0, 3.0, 4.5 or 6.0 kW) in the Touch Panel Controller's Install menu before igniting
the new lamp. This setting establishes the proper range of power available for the
installed lamp, ensuring that the new lamp is neither under-powered nor over-driven.
WARNING
and the lamp may not ignite.
MAINTENANCE
ON
.
6-9