Position Cp2000 At Port Window; Assembling Projection Head With Pedestal; Centering - Christie CP2000 User Manual

LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)
Figure 2.1. Assembling Projection Head with Pedestal
5-3)
Lift the projection head on to the pedestal, aligning 4 threaded rods with 4
holes in pedestal frame. The front of the head will seat on the front of the
pedestal frame, and the rear will be elevated by the safety prop.
5-4)
Retract the safety prop until the rear of the projection head seats on the
rear of the pedestal frame. All 4 threaded rods will be fully inserted
through the holes in the top of the pedestal. Secure prop (do not leave
loose).
5-5)
Secure head-pedestal assembly with 4 washers/nuts tightened snugly on to
the 4 threaded rods (use ¾" wrench).

2) Position CP2000 at port window

Roll the projector until its base is approximately 2 feet from the port window wall, 3
feet if anamorphic lens mount will be added (optional). Center with the theatre screen
() if possible (see Figure 2.2A). If forced to be off-center (such as when a film
projector is already present), try to optimize aim as shown in Figure 2.2B. This will
slightly increase side keystoning, but will minimize horizontal lens offset required.
NOTE: Unlike film projectors, it is best to keep the projector lens surface as parallel
to the screen as possible, even if it is significantly above the screen center.
Figure 2.2. Centering 
INSTALLATION AND SETUP
(AERIAL VIEWS)
2-3