Christie CP2000 User Manual page 143

ASCII MESSAGES
B-4
Function Code / Examples
LampLOC Module (LLM)
(LLM000 000 0158)
Lamp Message Enable (LME)
(LME 0)
(LME 1)
Lamp Mode (LPM)
(LPM S101 2)
(LPM! G 002)
Lamp Per Button (LPB)
(LPB O)
(LPB?)
(LPB! 1)
Lamp Power (LPP)
(LPP 2000)
(LPP?)
(LPP!2000)
Lens Auxiliary (LNA)
requires v2.7 or higher
(LNA "1.25AN" "1234567")
Lens Primary (LNP)
requires v2.7 or higher
(LNA "1.25AN" "1234567")
Measured Color Gamut (MCG)
(MCG "OnSite")
(MCG?)
(MCG! OnSite)
Ping (PNG)
(PNG?)
(PNG! 032 001 002)
Description and Parameters
Single Parameter:
1=calibrate stepper motors
2=Do AUTO lamp alignment (LampLOC)
Multiple Parameter:
P1 = 0, move motor
P2 = Which motor...x(0), y(1), or z(2)
P3 = Destination / new motor position (-200 up to +200)
0 = No lamp message will appear when lamp limit expires
1 = Lamp message will appear when lamp limit expires
2 = Constant power
3 = Constant light intensity (LiteLOC mode)
NOTE: 1) Specify desired channel with "S". If no "S" parameter is
included, the LPM setting will apply to the current channel when the "Lamp
Per Channel" checkbox is enabled, and to all channels when the checkbox
is cleared. 2) Specify global parameter with "G".
Changes mode for channel 101 to constant power
Reply to global power mode request
0 = Off; Lamp settings will be the same for all channels.
1 = On; Lamp settings will vary according to channel.
NOTE: This setting determines whether lamp mode, power and intensity
are the SAME for every channel (i.e., global) or DIFFERENT for each.
Specific power setting (#watts) for driving the lamp.
Range = depends on the installed lamp
NOTE: Specify desired channel with "S". If no "S" parameter is included,
the LPP setting will apply to the current channel when the "Lamp Per
Channel" checkbox is enabled, and to all channels when the checkbox is
cleared.
P1 = Lens type
Valid lens = "1.25 AN" or "1.25WC"
P2 = Lens serial number
P1 = Lens type
P2 = Lens serial number
Valid Lens:
"1.25-1.45HC"
"1.45-1.8HC"
"1.8-2.4HC"
"2.2-3.0HC"
"3.0-4.3HC"
"4.3-6.0HC"
"5.5-8.5HC"
"1.25-1.45HB"
"1.45-1.8HB"
"1.8-2.4HB"
"2.2-3.0HB"
"3.0-4.3HB"
"4.3-6.0HB"
"5.5-8.5HB"
Use OnSite MCGD as the reference point for color proc.
What MCGD is currently in use?
Reply indicating the OnSite MCGD is in use
Request for projector type and current s/w version
Reply indicating cinema projector present (32), and its
current version of software is v1.2
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)