Admin/General And Admin/Lamp Submenus - Christie CP2000 User Manual

BASIC OPERATION
3-38
NOTE: The new projector address will also be implemented in the
Admin:General menu, so that the TPC will look for this projector when you have
finished setting up all network changes.
5. When a new address is implemented in the projector, another dialogue box will
remind you that if your settings moved the projector to a different network (most
common), the TPC will no longer be able to
control the projector. You must therefore
immediately change the TPC Ethernet
configuration if you have changed either or
both of the following:
•
Any of the first 3 octets of the "IP
Address" (i.e., the network node)
•
The Subnet Mask
Make sure to change the TPC address before re-booting the projector.
For both devices—projector and TPC—the Subnet Mask and the
first 3 octets of their IP addresses must match, otherwise the
devices are on different networks and cannot communicate.
Do not re-boot until this match is confirmed.
You do not have to change the TPC Ethernet configuration if you have changed
only the last octet of the projector's "IP Address". In this case (rare), both devices
still belong to same network and will be able to communicate with each other.
6. Change the TPC Ethernet network configuration (below).
HOW TO CHANGE YOUR TPC'S IP ADDRESS:
menu, then change the TPC's IP address in the same manner as you changed the
projector's address.
The first 3 octets of the IP address must match
those for the projector. See Steps 2 and 3, above.
NOTE: This is the simplified explanation of valid addressing. A trained network
administrator may expand the range of valid addresses.
To implement the address changes in your projector and TPC, re-boot.
IMPORTANT: Do not forget to re-boot the projector.

Admin/General and Admin/Lamp Submenus

NOTE: Installer login required.
From within the Admin menu, an installer can access three additional submenus not
available to any other user. These submenus are primarily for defining critical system
parameters such as the projector's IP address, lamp type, and user rights for remote
access and data logging. Installers can also record minimum and maximum
footlambert readings to define a range from which other TPC lamp readings are
Ignore any "Cancel" button that may appear
in this dialogue box.
WARNING
Select "TPC" at the top of the IP Config
WARNING
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)