Adjust 4 Feet For Tilt And Leveling; Open Rear Of Pedestal - Christie CP2000 User Manual

INSTALLATION AND SETUP
2-22
1. Disconnect the
projector from AC
power.
2. Use a wrench to
rotate front and rear
feet until projector tilt
matches screen tilt.
You can achieve up
to 12° tilt by
adjusting the feet. See
right.
In rare cases where additional tilt is needed, you can utilize the rear extender legs as
described below.
IMPORTANT: For best optical performance, avoid tilting the projector excessively.
Use vertical offset of the lens instead.
4. Remove the
rear bottom
panel (2 top
screws, 2
bottom tabs)
from the CP
pedestal.
5. Use a low-
profile scissor
jack to elevate
the rear of the
projector.
6. On each side
of the rear opening in the pedestal, loosen the 2 bolts securing the rear extender
legs to the projector. See Figure 2.30.
Figure 2.27. Adjust 4 Feet for Tilt and Leveling
Figure 2.28. Open rear of pedestal
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)