Tpc User Access Rights - Christie CP2000 User Manual

LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)
Figure 3.4. TPC User Access Rights
A simple design with familiar menu icons enables a novice user to display an
accurate and fully optimized image by pressing a single button on the touch-screen—
and precisely configured presentations are protected from accidental or unauthorized
change.
TRAINED OPERATORS, ADVANCED USERS, ADMINISTRATORS and INSTALLERS:
addition to the basic user rights shown in the "Any User" above, the TPC offers four
distinct password-protected levels of use (shown in shaded areas in Figure 3.4). Each
has all of the rights of lower levels, plus additional rights as described below:
Trained Operators can also access the New Lamp function required when
replacing the lamp.
Advanced users can access two additional menus (Custom and Advanced) where
they can define all display setups and set the DVI processing path, configure 3D
displays, optimize light output, record lamp changes, activate test patterns and set
certain system preferences.
Administrators can also use four Admin submenus—Source, Screen, color Gamut
IP Config, and GPIO—to define setup files as selectable choices for processing a
variety of incoming signals. Source files set incoming resolution, offset (rare) and
desired final aspect ratio, Screen files determine image cropping (masking), size of
display area, and type of lens, and color Gamut information ensures color display
standards are properly met in the current environment. In the IP Config menu, the
administrator can define new Ethernet settings (IP network addresses) for the
projection head and TPC. In the GPIO menu, the administrator can select pre-
defined GPI or GPO macros.
Installers and other Service personnel can access two additional configuration
menus (General, and Lamp) as well as three more Status submenus (Server, Diag
and Interrogator). The installer can define system operating parameters such as
which projector is controlled by the TPC, and critical lamp parameters such as
installed lamp type, fan speed and light level at the screen. Installers can also
establish temperature scale preference, remote access rights, test pattern access
BASIC OPERATION
In
3-9