Table of Contents
Advertisement
B
Lock
C
Turn to adjust height
2. Extend or retract the feet.
3. When the adjustment is correct, tighten the lock nut.
Installing the touch panel controller
Attach the touch panel controller to the projector.
1. Attach the mounting bracket to the touch panel controller using the three M4 screws and the 3
mm hex driver provided.
2. Slide the mounting bracket into the bracket support.
3. Connect the connector from the touch panel controller to the port on the side of the projector.
CP2208-LP Installation and Setup Manual
020-102152-03 Rev. 1 (05-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installing and setting up
15
Advertisement
Table of Contents
