Install Bulb - Christie CP2000 User Manual

MAINTENANCE
STEP 7 
STEP 8 
6-8
6.3. Handling by the cathode end only, unscrew the lamp from the rear connector and
carefully remove from the projector. Immediately place the lamp inside the
protective cover (saved from previous installation) and then seal it in a heavy
carton on the floor where it cannot fall or be bumped.
Handle box with extreme caution—the lamp is hazardous
even when packaged. Dispose of lamp box according to
6.4. With the lamp removed, visually inspect the reflector for dust. Clean if necessary
as described in 6.3, Maintenance and Cleaning.
Remove new lamp from protective cover
7.1. Remove tape, knurled nut and locking star washer (if present) securing the lamp
within its cover.
7.2. Handling at the ends only, extract the lamp from the cover. Set aside the
protective cover for re-use in your next lamp disposal or for warranty return of an
expired lamp.
Install new lamp
8.1. With protective clothing and shield on, insert the threaded cathode (–) end of the
lamp into the negative lamp connector nut located in the rear of the lamp
compartment and screw in fully (Figure 6.1, left). Hand-tighten only.
Handle by the cathode/anode end shafts only,
never the glass. Do not over-tighten. Do not stress the glass.
8.2. Rest the anode (+) end of the lamp on the lamp cradle as shown in Figure 6.1,
right, and slip the positive lamp connector over the bulb end.
WARNING
safety regulations for your area.
CAUTION
Figure 6.1. Install Bulb
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)