Installing The Touch Panel Controller; Installing The Lens; Installing The Lamp - Christie CP2208 User Manual

Installing the touch panel controller

Attach the touch panel controller to the projector.
1. Attach the mounting bracket to the touch panel controller using the three M4 screws and the 3
mm hex driver provided.
2. Slide the mounting bracket into the bracket support.
3. Connect the connector from the touch panel controller to the port on the of the projector.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.

Installing the lamp

Complete the following procedure to install the lamp.
Warning! If not avoided, the following could result in death or serious injury.
• This procedure must be performed by Christie qualified technicians.
• EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
• Do not open the lamp door while the lamp is on.
• EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
• EXPLOSION HAZARD! Lamps and bare bulbs, even when packaged, may explode if dropped or
mishandled.
1. If the projector is operating, turn it off and allow it to cool a minimum of 15 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Disconnect the touch panel communication cable from the rear of the projector.
5. Remove the from the rear of the projector.
6. Put on your protective clothing, face shield, and gloves.
7. Insert the key in the lamp door lock, turn the key, and then open the lamp door.
8. Loosen the two thumbscrews and open the firewall door.
9. Loosen the two thumbscrews and open the lamp access door.
10. Loosen the cathode clamp with the 5 mm hex key attached to the lamp door.
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
17