Selecting A Display; Summary Of Admin:general Menu Functions; Summary Of Admin:lamp Menu Functions - Christie CP2000 User Manual

Selecting a Display 
(Starting a Presentation)
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)
interpolated, and they can set whether Status menu temperatures appear in Celsius
(default) or Fahrenheit. A typical Admin:General submenu appears below.
Table 3.10. Summary of Admin:General Menu Functions
Projector IP Address
Image Orientation
Celsius Display
Remote Access
Data Logging
Error Message Enabled
Table 3.11. Summary of Admin:Lamp Menu Functions
Footlamberts Calibration
NOTES: 1) For manual operation (i.e., non-automated). 2) In order to use the TPC
software originally shipped with the projector, the installer typically connects a
laptop and uses Christie's DCP Librarian setup software to download all necessary
configuration files to the projector for use at the TPC.
To change to a new source—i.e., a new presentation or display—do the following:
•
Make sure the CP2000 and TPC are both powered up and operating normally
•
On the Touch Panel Controller (TPC), select the Main menu tab
•
On either of the Main menu pages, press the desired display button—the image
will update accordingly
See Figure 3.33.
ADMIN:GENERAL MENU FUNCTIONS
Determines which projector the TPC controls, and always
terminates in 10-99. All four values (octets) must be valid for
your site. For example, perhaps you can use the default
192.168.206.10 to control a single-projector installation. Then
use 192.168.206.11 to control a second projector at that site,
192.168.206.12 to control a third projector, and so on.
NOTE: This menu does NOT define the projector's address!
Define the orientation of the screen relative to the projector.
Choose Celsius or Fahrenheit temperature display for Status
menu.
Define whether all users can access TPC functions remotely or
not at all, or whether a login is required.
Define the extent of activity to record in an Ethernet-accessible
TPC data log (default=Errors only). A good data log can be
helpful when troubleshooting, but use with caution— "Detailed"
logging will slow TPC responses. Note that when the memory
card becomes full, logging continues and simply writes over
the oldest entries.
When enabled, an error message will be sent via Ethernet
whenever an alarm condition is encountered.
ADMIN:LAMP MENU FUNCTIONS
Activate each text box to automatically drive the lamp at its
minimum or maximum power. Record light measured at the
screen for both extremes in power, defining a range of
footlamberts possible. Light readings (fL) appearing
elsewhere in TPC will then be interpolations based on this
range. Push SAVE to implement new values. NOTE: Re-
calibration must be done with new lamp change.
BASIC OPERATION
3-39