Installing The Security Kit (Option) - Kyocera KM-6030 Service Manual

1-3-8

Installing the security kit (option)

• Before installing the security kit, press the Power key on the operation panel to off. Make sure that the Power lamp is
off before turning off the main power switch. And then unplug the power cable from the wall outlet.
Turning off the main power switch before pressing the Power key to off may cause damage to the equipped hard
disk.
• If the machine is using a hard disk already, installing the security kit will not erase hard disk data automatically.
To delete data, you need to consult your customer. Refer to the operation guide to format the hard disk for deletion of
the data.
Procedure
1. Remove the nine screws, and then remove
the rear middle cover.
2. Remove the eight screws, and then remove
the right sequence cover.
Rear middle cover
Figure 1-3-67
Right
sequence
cover
Screws
Figure 1-3-68
2FB/2FC-2.0
Screws
Screws
Screws
Screws
Screws
Screws
1-3-33