Fuser Section - Kyocera KM-6030 Service Manual

2FB/2FC
2-1-7

Fuser section

The fuser section consists of the parts shown in the figure.
When the paper reaches the fuser section after the transfer process, it passes through the gap between the press roller
and heat roller, which is heated by fuser heaters M, S and L (FH-M, FH-S and FH-L).
where pressure is applied by the pressure springs so that toner on the paper is melted and fused onto the paper
When the fuser process is completed, the paper is separated from the heat roller and press roller by their separation claws
and is ejected out of the copier by the rotation of the fuser eject pulley and roller.
The cleaning felt in contact with the heat roller cleans the surface of the heat roller.
The lower cleaning roller in contact with the press roller cleans the surface of the press roller.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10) Fuser stay
(11) Fuser thermostat (FTS)
(12) Fuser thermistor M (FTH-M)
2-1-20
Figure 2-1-23 Fuser section
Fuser base
Press roller
Fuser A front guide
Fuser eject mount guide
Lower cleaning roller
Fuser eject lower guide
Press roller separation claw
Heat roller
Fuser upper guide
(13) Fuser thermistor S (FTH-S)
(14) Fuser heater L (FH-L)
(15) Fuser heater M (FH-M)
(16) Fuser heater S (FH-S)
(17) Fuser cleaning support plate
(18) Web pressure roller
(19) Cleaning felt
(20) Fuser cleaning cover
(21) Upper fuser cover
(22) Fuser eject upper plate
(23) Fuser eject upper guide
(24) Heat roller separation claw