Adjusting Magnification Of The Scanner In The Main Scanning Direction - Kyocera KM-6030 Service Manual

(7) Adjusting magnification of the scanner in the main scanning direction

Perform the following adjustment if the magnification in the main scanning direction is not correct.
.
U066
U065
(P. 1-6-54)
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
When making this adjustment, moire occurs.
<Procedure>
Start
Enter maintenance mode.
Enter 065 using the numeric keys.
Press the start key.
Select MAIN SCAN ADJ
(main scanning direction).
Press the interrupt key.
Place an original and press
the start key to make a test copy.
Is the image correct?
Press the stop/clear key.
Exit maintenance mode.
End
U067
(P. 1-6-53)
No
Yes
Front (CCD adjustment)
U403
(P. 1-6-55) (P. 1-6-91)
Back (CIS adjustment)
(P. 1-6-91)
Original
Press the start key.
The new setting
is stored.
For copy example 1, increase the
value using the cursor up key.
For copy example 2, decrease the
value using the cursor down key.
Setting range: -25 to +25
Initial setting: 0
Changing the value by 1 changes
the magnification by 0.1%.
Increasing the value makes
the image wider, and decreasing it
makes the image narrower.
U070 U072
(P. 1-6-92)
U070 U072
(P. 1-6-92)
Copy
example 2
example
Figure 1-6-99
2FB/2FC-3
U404
(P. 1-6-95)
U404
(P. 1-6-95)
Copy
1-6-51