Kyocera KM-6030 Service Manual page 112

Maintenance
item No.
Setting the fuser control temperature
U161
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper, or solve a
fuser problem on thick paper.
Method
1. Press the start key. The screen for selecting an item is displayed.
Display
PAGE1
PAGE2
2. Select the item to be set and press the start key. The screen for setting is displayed.
Setting: PAGE1
1. Select the item to be set. The selecting item is displayed in reverse.
Display
CONT TEMP
1ST TEMP
2ND TEMP
TIME
DUPLEX
WARM UP TIME
2. Change the setting using the cursor up/down keys.
The respective temperatures are to be set such that 2ND TEMP >= 1ST TEMP.
3. Press the start key. The value is set.
Setting: PAGE2
1. Select the item to be set. The selecting item is displayed in reverse.
Display
DUPLEX2
SMALL
SPEED DOWN
2. Change the setting using the cursor up/down keys.
3. Press the start key. The value is set.
Description
Control temperature during copying, primary stabilization fuser temperature, sec-
ondary stabilization fuser temperature, aging time after secondary stabilization,
control temperature adjustment in duplex copying and time from power on to stabi-
lization of fusing.
Control temperature adjustment in duplex copying using A4/Letter/B5 size paper
and control temperature adjustment when the fuser heater temperature goes low.
Setting
Control temperature during copying
Primary stabilization fuser temperature
Secondary stabilization fuser temperature 100 to 230
Aging time after secondary stabilization
Control temperature adjustment in duplex
copying
Time from power on to stabilization of
fusing
Setting
Control temperature adjustment in duplex
copying using A4/Letter/B5 size paper
(when optional document finisher is not
installed)
-
Control temperature adjustmen when the
fuser heater temperature goes low
Description
Setting range Default setting
100 to 230
°
( C)
100 to 200
°
( C)
°
( C)
0 to 255 (s)
-30 to 0 (
0 to 255 (s)
Setting range Default setting
-30 to 0 (
-
-10 to 10 (
2FB/2FC-3
200 (80 cpm)
195 (60 cpm)
175 (120 V)
140 (220-240 V)
185
60
°
-10
C)
26
°
-15
C)
-
°
0
C)
1-4-37