Adjusting Magnification Of The Scanner In The Auxiliary Scanning Direction - Kyocera KM-6030 Service Manual

2FB/2FC-3

(8) Adjusting magnification of the scanner in the auxiliary scanning direction

Perform the following adjustment if the magnification in the auxiliary scanning direction is not correct.
U066
U065
(P. 1-6-54)
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
<Procedure>
Enter maintenance mode.
Enter 065 using the numeric keys.
Press the start key.
Select SUB SCAN ADJ
(auxiliary scanning direction).
Press the interrupt key.
Place an original and press
the start key to make a test copy.
Is the image correct?
Press the stop/clear key.
Exit maintenance mode.
1-6-52
U403
(P. 1-6-55)
Start
No
Yes
End
Front (CCD adjustment)
U070 U071
(P. 1-6-91) (P. 1-6-93)
Back (CIS adjustment)
U070 U071
(P. 1-6-91) (P. 1-6-93)
Original
Press the start key.
The new setting
is stored.
For copy example 1, increase the
value using the cursor up key.
For copy example 2, decrease the
value using the cursor down key.
Setting range: -25 to +25
Initial setting: 1
Changing the value by 1 changes
the magnification by 0.1%.
Increasing the value makes
the image longer, and decreasing it
make the image shorter.
U404
(P. 1-6-95)
U404
(P. 1-6-95)
Copy
Copy
example 2
example
Figure 1-6-100