Kyocera KM-6030 Service Manual page 448

2FB/2FC-2.0
Maintenance
Section
part/location
Fuser Lower cleaning roller
section
Press roller
Press roller separation
claws
Cleaning felt
Fuser thermistor
Fuser heater M/S/L
Heat roller
Heat roller separation
claws
Heat roller gear
Fuser joint gear
Fuser eject upper
roller
Gear 88 fuser
Guides
Maintenance
Section
part/location
Duplex Rollers
section
Guides
Duplex feedshift sole-
noid
Duplex switchback
solenoid
Maintenance
Section
part/location
Feedshift Feedshift solenoid
section
Rollers
Guides
2-4-10
Method Maintenance cycle
Replace Every service
Replace Every service
Clean Every service
Replace Every service
Check and Every service
replace
Check and Every service
replace
Replace Every service
Replace Every service
Check and Every service
replace
Replace and Every service
grease
Replace Every service
Grease Every service
Clean Every service
Method Maintenance cycle
Clean Every service
Clean Every service
Check and Every service
replace
Check and Every service
replace
Method Maintenance cycle
Check and Every service
replace
Clean Every service
Clean Every service
Points and cautions
Replace if the film is
scraped.
Replace if it is blackened.
When replacing with the
new gear, after cleaning the
shaft, apply grease EM-50L
to the gear inside.
Replace after feeding
1000,000 sheets.
Apply grease EM-50LS.
Clean with alcohol or a dry cloth.
Points and cautions
Clean with alcohol or a dry cloth.
Clean with alcohol or a dry cloth.
Run maintenance item U922
to check and clear the count.
Points and cautions
Run maintenance item U922
to check and clear the count.
Clean with alcohol or a dry cloth.
Clean with alcohol or a dry cloth.
Page
P.1-6-71
P.1-6-72
P.1-6-73
P.1-6-75
P.1-6-76
P.1-6-79
P.1-6-80
P.1-6-79
P.1-6-79
P.1-6-81
Page
P.1-4-72
Page
P.1-4-72