Kyocera KM-6030 Service Manual page 138

Maintenance
item No.
Setting the value for maintenance due indication
U345
Description
Sets when to display a message notifying that the time for maintenance is about to be reached, by setting the
number of copies that can be made before the current maintenance cycle ends.
When the difference between the number of copies of the maintenance cycle and that of the maintenance
count reaches the set value, the message is displayed.
This maintenance mode is effective for only Japanese specification.
Adjusting margins of image printing
U402
Adjustment
See page 1-6-28.
Adjusting margins for scanning an original on the contact glass
U403
Adjustment
See page 1-6-55.
Adjusting margins for scanning an original from the DP
U404
Adjustment
See page 1-6-95.
Adjusting the leading edge registration for memory image printing
U407
Adjustment
See page 1-6-18.
Adjusting the laser output
U467
Description
Adjusts the laser output power.
Purpose
The setting need not be changed.
Method
Press the start key. The screen for adjustment is displayed.
Setting
1. Change the setting using the cursor up/down keys.
Setting range: 0 to 255
Initial setting: 200 (80 cpm), 150 (60 cpm)
A larger preset value causes dots and lines to be clearly large and thick and the reference density to be
darker.
A smaller preset value causes dots and lines to be clearly small and thin and the reference density to be
lighter.
Although three lasers (ADJUST DATA1, ADJUST DATA2 and ADJUST DATA3) can be adjusted sepa-
rately, be sure to set the same value. If different values are set, proper images cannot be obtained.
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
Description
2FB/2FC
1-4-63