Kyocera KM-6030 Service Manual page 206

Code
C8310 Document finisher* centerfold unit
side registration guide problem
• During initialization, the front/rear side
registration guides are not detected in
the home position within 600 ms after
the guide returns to the home position.
• When the side registration guide is
operated from the home position, the
side registration guide home position
sensor does not turn off within 100 ms.
C8320 Document finisher* centerfold unit
centering plate problem
• During initialization, the centering plate
is not detected in the home position
when the centering plate returns to the
home position.
Contents
Causes Check procedures/corrective measures
Loose connection Reinsert the connector. Also check for conti-
of the side registra- nuity within the connector cable. If none,
tion guide motor remedy or replace the cable.
connector.
Malfunction of the Replace the side registration guide motor
side registration and check for correct operation.
guide motor.
Malfunction of the Replace the side registration guide home
side registration position sensor and check for correct opera-
guide home posi- tion.
tion sensor.
Loose connection Reinsert the connector. Also check for conti-
of the side registra- nuity within the connector cable. If none,
tion guide home remedy or replace the cable.
position sensor
connector.
Defective center- Replace the centerfold unit main PWB and
fold unit main check for correct operation.
PWB.
Loose connection Reinsert the connector. Also check for conti-
of the centering nuity within the connector cable. If none,
plate motor con- remedy or replace the cable.
nector.
Malfunction of the Replace the centering plate motor and
centering plate check for correct operation.
motor.
Malfunction of the Replace the centering plate home position
centering plate sensor and check for correct operation.
home position sen-
sor.
Loose connection Reinsert the connector. Also check for conti-
of the centering nuity within the connector cable. If none,
plate home posi- remedy or replace the cable.
tion sensor con-
nector.
Defective center- Replace the centerfold unit main PWB and
fold unit main check for correct operation.
PWB.
Remarks
2FB/2FC-4
1-5-45