Switches And Sensors (Dp) - Kyocera KM-6030 Service Manual

(6) Switches and sensors (DP)

6
1. DP safety switch 1 (DPSSW1)..................... Breaks the safety circuit when the document processor is opened; resets
2. DP safety switch 2 (DPSSW2)..................... Breaks the safety circuit when the document processor top cover is
3. Original set switch (OSSW) ......................... Detects the presence of an original.
4. Original feed switch (OFSW) ....................... Detects primary original feed end timing.
5. Original registration switch (ORSW) ............ Detects the original conveying timing.
6. DP timing switch 1 (DPTSW1) ..................... Detects the original scanning timing.
7. DP timing switch 2 (DPTSW2) ..................... Detects the original scanning timing.
8. Original length size switch (OLSW) ............. Detects the length of the original.
9. Original width size switch (OWSW) ............. Detects the width of the original.
10. DP lift upper limit switch (DPLULSW) .......... Detects the lift table reaching the upper limit.
11. DP lift lower limit switch (DPLLLSW) ........... Detects the lift table reaching the lower limit.
12. CIS open/close switch (CISOCSW) ............. Detects the opening/closing of the document processor bottom cover.
10 2
4
3
5
11
12
7
Machine front
Figure 2-2-6 Switches and sensors (DP)
original misfeed detection.
opened; resets original misfeed detection.
9
Machine inside Machine rear
2FB/2FC
8
1
2-2-9