Kyocera KM-6030 Service Manual page 57

2FB/2FC
[Correcting paper curling]
1. Set the machine in the non-sort mode and
run paper through the machine to make a
test copy.
2. Check if the paper that is ejected from the
finisher is curled. If it is, make the following
adjustment.
• If the paper curls downward (a of figure 1-3-
42)
1. Open the front cover.
2. Rotate the lower lever by one mark in the
direction of the higher numbers.
There are 5 marks.
3. Close the front cover.
4. Run paper through the machine and check if
it is still curled downward.
5. Repeat steps 1 to 4 until the ejected paper
does not curl downward anymore.
• If the paper curls upward (b of figure 1-3-42)
1. Open the front cover.
2. Remove the three screws locking down the
inner left cover followed by the cover.
1-3-22
a b
Figure 1-3-42
Lower lever
1
2
3
4
5
Figure 1-3-43
Inner left cover
Screws
Figure 1-3-44