Kyocera KM-6030 Service Manual page 167

2FB/2FC
Section Jam code
DP section 00
Optional 80
document
finisher
81
82
83
84
85
86
87
88
89
90
91
92
1-5-8
Description
System error jam
Jam between the finisher
and copier
Paper jam during paper
insertion to the finisher
Paper jam during paper
insertion to the finisher
and paper ejection to the
sub tray
Paper jam at the siding
drum
Paper jam during paper
insertion to the intermedi-
ate tray
Paper jam during ejection
of stack of paper
Jam in eject section of
main tray
Jam in eject section (mid-
dle tray) of main tray
Jam in eject section of
main tray
Jam in cover open
Jam in stapler
Jam in saddle paper entry
section
Jam in saddle paper entry
section
The document processor top cover is opened during original
feeding.
CIS is opened during original feeding.
DP is opened during original feeding.
The power source is turned on when the original is remained
in the original conveying path.
The start key is pressed when the original is remained in the
original conveying path.
Paper ejection is not output from the copier to the document
finisher within 15 s of the face-up exit sensor (FUES) turning
off.
When the paper entry sensor (PES) does not turn on within
1950 ms of the face-up exit sensor (FUES) of the copier turn-
ing off.
When the sub tray paper ejection sensor (STPES) does not
turn on within 2000 ms of the paper entry sensor (PES) turning
on.
When the paper entry sensor (PES) does not turn off within
1500 ms of its turning on.
When the sub tray paper ejection sensor (STPES) does not
turn off within 1000 ms of its turning on.
When the intermediate tray paper conveying sensor (ITPCS)
does not turn on within 1200 ms of the paper entry sensor
(PES) turning on.
When the paper entry sensor (PES) does not turn off within
1500 ms of its turning on.
When the intermediate tray paper conveying sensor (ITPCS)
does not turn on within 2000 ms of the sub tray paper ejection
sensor (STPES) turning on.
When the intermediate tray paper conveying sensor (ITPCS)
does not turn off within 1000 ms of its turning on.
When straight ejection is performed, the paper ejection sensor
(PEJS) is not turned on even if 2600 ms elapse after the paper
entry sensor (PES) is turned on.
The paper ejection sensor (PEJS) is not turned on even if
2600 ms elapse after bundled ejection from the intermediate
tray starts.
When the paper ejection sensor (PEJS) does not turn off
within 2600 ms of its turning on.
During operation, any of safety switches (upper cover switch
(UCSW), front cover switch (FCSW), and centerfold unit set
switch (CUSSW) is turned off.
The front/rear stapler home position sensor (STHPS-F/R) or
front/rear clincher home position sensor (CLNHPS-F/R) can-
not detect normally the home position.
The lower paper sensor (PS-L) is not turned on even if 3000
ms elapse after bundled ejection to the centerfold unit starts.
The centerfold unit paper entry sensor (CUPES) is not turned
on even if 2000 ms elapse after sorter ejection notification
(serial communication data from the finisher main body to the
centerfold unit).
Conditions