Adjusting The Center Line For Cassette 1 Or 2 - Kyocera KM-6030 Service Manual

(4) Adjusting the center line for cassette 1 or 2

Perform the following adjustment if there is a regular error between the center lines of the copy image and original when
the paper is fed from cassette 1 or 2.
Caution
After performing the following adjustment, adjust the position of the damper (see page 1-6-16).
Procedure
Start
Enter maintenance mode.
Enter 034 using the numeric keys.
Press the start key.
Select LSUOUT
on the touch panel.
Press the interrupt key.
Select cassette 1 or 2.
Press the start key to output a test
pattern.
Is the image correct?
Yes
Press the stop/clear key to exit
maintenance mode.
End
Tighten five screws securing
cassette 1 or 2.
Loosen five screws securing
cassette 1 or 2 and adjust
the position.
For output example 1, move cassette
1 or 2 in the direction of black
No
arrow ( ).
Cassette1 or 2
Screws
Center line of printing
Correct image Output
example 1
Figure 1-6-31
For output example 2, move cassette
1 or 2 in the direction of white
arrow ( ).
Screw
Graduation
Figure 1-6-32
2FB/2FC
Output
example 2
Screws
1-6-15