Adjusting The Scanner Center Line - Kyocera KM-6030 Service Manual

(9) Adjusting the scanner center line

Perform the following adjustment if there is a regular error between the center lines of the copy image and original.
U403
U067
(P. 1-6-55)
<Caution>
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
<Procedure>
Enter maintenance mode.
Enter 067 using the numeric keys.
Press the start key.
Select ADJUST DATA
or ADJUST DATA2
on the touch panel.
Press the interrupt key.
Place an original and press
the start key to make a test copy.
center line correct?
Press the stop/clear key.
Exit the maintenance mode.
Front (CCD adjustment)
U072
(P. 1-6-92)
Back (CIS adjustment)
U072
(P. 1-6-92)
Start
Is the scanner
No
Yes
End
U404
(P. 1-6-55)
U404
(P. 1-6-55)
Scanner center line
Original
Touch panel display
ADJUST DATA:
Center line for simplex copy mode
ADJUST DATA2:
Center line for duplex copy mode (second face)
Press the start key.
The new setting
is stored.
For copy example 1, increase
the value using the cursor up key.
For copy example 2, decrease
the value using the cursor down key.
Setting range (initial setting)
Center line for simplex copy mode:
-48 to +48 (0)
Center line for duplex copy mode
(second face): -7 to +7 (0)
Changing the value by 1 moves
Center line for simplex copy mode: 0.17 mm
Center line for duplex copy mode
(second face): 0.084 mm
Copy Copy
example 1 example 2
Figure 1-6-101
2FB/2FC-3
1-6-53