Installing The Printer Kit (Option) - Kyocera KM-6030 Service Manual

Hide thumbs Also See for KM-6030:

Table of Contents

Installing the printer kit (option)

Before installing the printer kit, press the Power key on the operation panel to off. Make sure that the Power lamp is

off before turning off the main power switch. And then unplug the power cable from the wall outlet.

Turning off the main power switch before pressing the Power key to off may cause damage to the equipped hard

Install the printer board.

1. Remove three screws and then remove the

2. Slide in the printer board along the rails, and

then secure it with the three screws and two

M4 x 8 tap tight S screws.

Install the optional printer network kit.

1. Remove the two pins, and then remove the

2. Slide in the printer network kit along the

rails, and then secure it with the two pins.

Figure 1-3-56

tight S screw

tight S screw

Figure 1-3-57

Figure 1-3-58

Printer board

Show Quick Links

Table of Contents