Kyocera KM-6030 Service Manual page 108

Hide thumbs Also See for KM-6030:
Table of Contents

Advertisement

Maintenance
item No.
Checking the toner level detection sensor
U137
Description
Displays the detection status of the toner level detection sensor and toner container.
Purpose
To check the toner level in the developing unit and toner container.
Method
1. Press the start key.
A list of switches, the on-off status of which can be checked, are displayed.
2. Turn each switch on and off manually to check the status.
When the on-status of a sensor is detected, that sensor is displayed in reverse.
Display
DLP SENS
CONT SENS
CONT SET SW
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting for toner applying operation
U147
Description
Sets the mode for removing charged toner in the developer unit (T7 control: Toner applying operation).
Purpose
There is no necessity of changing the setting as for initial setting for factory default setting is automatic mode.
However, the original whose always print coverage ratio is low (reference: less than 2%) it outputs in large
quantities, setting in MODE5 fixed possibility.
If the charged toner stays inside the development unit, density decreases.
The number of MODE becomes large, so that the amount of removal toner increases.
Start
Press the start key. The screen for selecting an item is displayed.
Display
MODE
INTERVAL
MODE6 DATA
Method: Toner applying operation mode
1. Select MODE at the screen for selecting an item.
2. Change the setting using the cursor up/down keys.
Setting
Toner applying operation mode
The mode is automatically determined when selecting 6 (MODE6).
3. Press the start key. The setting is set.
Detail for MODE
Average print cover-
age ratio (%)
Over 0 to less than 1
Over 1 to less than 2
Over 2 to less than 3
Over 3 to less than 4
Over 4 to less than 5
Over 5
Description
Description
Developing sensor (DEVS)
Toner container sensor (TCS)
Toner container detection switch (TCDSW)
Description
Setting for toner applying operation mode
Displaying toner applying operation quantity
Displaying toner applying operation mode when setting MODE6
Setting range
2 to 6 (MODE2 to MODE6)
Toner applying width per A4/11x8 1/2
0
1
2
OFF
2.60 mm 3.38 mm 3.90 mm 5.21 mm 7.81 mm
OFF
1.30 mm 1.82 mm 2.34 mm 3.90 mm 5.99 mm
OFF
0.78 mm 1.04 mm 1.30 mm 2.60 mm 4.16 mm
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Default setting
6 (MODE6)
MODE
3
4
0.78 mm 1.56 mm 2.60 mm
OFF
0.78 mm 1.30 mm
OFF
OFF
OFF
Reference: 0.78 mm=3 mg
2FB/2FC-3
5
6 (AUTO)
MODE5
MODE5
MODE4
MODE3
MODE0
MODE0
1-4-35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Km-8030

Table of Contents