Kyocera KM-6030 Service Manual page 172

Problem Causes/check procedures
(10) Broken feed switch 2 actua-
A paper jam in the tor.
paper feed section is
Defective feed switch 2.
indicated during
copying (jam in
copier vertical paper
conveying section 4).
Broken feed switch 4 actua-
Jam code 21
tor.
Defective feed switch 4.
Broken feed switch 5 actua-
tor.
Defective feed switch 5.
Broken deck conveying
switch 1 actuator.
Defective deck conveying
switch 1.
The vertical feed roller or
deck conveying roller is
dirty with paper powder.
The vertical feed roller or
deck conveying roller is
deformed or worn.
(11) Broken deck conveying
A paper jam in the switch 1 actuator.
paper feed section is
Defective deck conveying
indicated during
switch 1.
copying (jam in deck
paper conveying sec-
tion 2).
Jam code 23
Broken deck conveying
switch 2 actuator.
Defective deck conveying
switch 2.
Defective the timing switch
1.
The deck conveying roller is
dirty with paper powder.
The deck conveying roller is
deformed or worn.
Corrective measures
Check visually and replace feed switch 2 if its actuator is broken.
Run maintenance item U031 and turn feed switch 2 on and off
manually. Replace feed switch 2 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Check visually and replace feed switch 4 if its actuator is broken.
Run maintenance item U031 and turn feed switch 4 on and off
manually. Replace feed switch 4 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Check visually and replace feed switch 5 if its actuator is broken.
Run maintenance item U031 and turn feed switch 5 on and off
manually. Replace feed switch 5 if indication of the corresponding
sensor on the touch panel is not displayed in reverse.
Check visually and replace deck conveying switch 1 if its actuator
is broken.
Run maintenance item U031 and turn deck conveying switch 1 on
and off manually. Replace deck conveying switch 1 if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Check and, if it is dirty, clean it.
Check and, if it is deformed or worn, fix or replace it.
Check visually and replace deck conveying switch 1 if its actuator
is broken.
Run maintenance item U031 and turn deck conveying switch 1 on
and off manually. Replace deck conveying switch 1 if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Check visually and replace deck conveying switch 2 if its actuator
is broken.
Run maintenance item U031 and turn deck conveying switch 2 on
and off manually. Replace deck conveying switch 2 if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Run maintenance item U031 and turn timing switch 1 on and off
manually. Replace timing switch 1 if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Check and, if it is dirty, clean it.
Check and, if it is deformed or worn, fix or replace it.
2FB/2FC-4
1-5-13