Fuser Section; Detaching And Refitting The Fuser Unit - Kyocera FS-1028MFP Service Manual

2H9
1-5-8

Fuser section

(1) Detaching and refitting the fuser unit

Procedure
1. Remove the left cover and right cover (See
page 1-5-3).
2. Remove the wires from three clamps.
3. Remove the connector from the power
source PWB.
4. Unhook four hooks and then remove the
frame left duct.
5. Remove the wires from the clamp.
1-5-34
Clamp
YC105
Connctor
Frame left duct
Hook
Clamp
Wires
Hook
Clamps
Power source
PWB
Figure 1-5-51
Hook
Hook
Frame left duct
Figure 1-5-52
Power source
PWB