Link Aggregation - Planet Networking & Communication WSGW-24020 User Manual

Operational Status
Admin Speed
Current Port Speed
Admin Duplex
Current Duplex Mode
Auto Negotiation
Current Auto Negotiation
Admin Advertisement
Current Advertisement
Neighbor Advertisement
Back Pressure
Current Back Pressure
Flow Control
Current Flow Control
MDI/ MDIX
Current MDI/MDIX
PVE
After setup complete, please click the Save button to save your changes.

4.3.2 Link Aggregation

When you enter the Link Aggregation, the screen appears in figure 4-11, such as: LAG, shows whether the port is part of a LAG.
This indicates the port is active or not.
Change the speed of each port.
Display current speed of each port.
Change the duplex mode of each port.
Display current duplex mode of each port.
Allow enable or disable per port's Auto Negotiation feature. If using an SFP module,
Auto Negotiation for the specific port should be set to disable.
Display current setting of the port's Auto Negotiation status.
Specifies the capabilities to be advertised by the port. Multiple options may be
selected or Max Capability can be selected to cover all of the options.
The available options are:
Max Capability, which indicates that the port speeds and duplex mode settings can
be accepted.
10 Half, indicates that the port is advertising a 10Mbps half duplex mode setting.
10 Full indicates that the port is advertising a 10Mbps full duplex mode setting.
100 Half, indicates that the port is advertising a 100Mbps half duplex mode setting.
100 Full indicates that the port is advertising a 100Mbps full duplex mode setting.
1000 Full, indicates that the port is advertising a 1000Mbps full duplex mode
setting.
The port advertises its capabilities to its neighbor port to begin the negotiation
process. This field displays the current advertisement settings.
Tthe neighbor port (the port to which the selected interface is connected) advertises
its capabilities to the port to start the negotiation process. This field displays the
neighbor's current settings.
The Back Pressure feature of the selected port can be enabled or disabled.
Displays whether Back Pressure is enabled or disabled on the currently selected port
The Flow Control feature of the selected port can be enabled or disabled.
Displays whether Flow Control is enabled or disabled on the currently selected port.
• Auto - the port to automatically detect the cable type.
• MDI - if the port is connected to an end station.
• MDIX - if the port is connected to a hub or another switch
Display the current MDI/MDIX status on each port.
For Gigabit Ethernet switches ONLY. When a port is a Private VLAN Edge (PVE) port,
it bypasses the Forwarding Database and forwards all unicast, multicast, and
broadcast traffic to an uplink. Uplinks can be ports or LAGs.
-38-
User's Manual of WGSW-24020/WGSW-48040