Appendex A; Switch's Rj-45 Pin Assignments; Cable Pin Assignment - Planet Networking & Communication WSGW-24020 User Manual

A.1 Switch's RJ-45 Pin Assignments
When connecting your 10/100Mbps Ethernet Switch to another switch, a bridge or a hub, a straight or crossover cable is
necessary. Each port of the Switch supports auto-MDI/MDI-X detection. That means you can directly connect the Switch to any
Ethernet devices without making a crossover cable. The following table and diagram show the standard RJ-45 receptacle/
connector and their pin assignments:
10/100Mbps, 10/100Base-TX
RJ-45 Connector pin assignment
Contact MDI
Media Dependant
Interface
1 Tx + (transmit)
2 Tx - (transmit)
3 Rx + (receive)
4, 5 Not used
6 Rx - (receive)
7, 8 Not used
1000Mbps, 1000Base T
RJ-45 Connector pin assignment
Contact MDI
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD-
Implicit implementation of the crossover function within a twisted-pair cable, or at a wiring panel, while not expressly forbidden,
is beyond the scope of this standard.
A.2 RJ-45 cable pin assignment
The standard cable, RJ-45 pin assignment
MDI-X
Media Dependant
Interface-Cross
Rx + (receive)
Rx - (receive)
Tx + (transmit)
Tx - (transmit)
MDI-X
BI_DB+
BI_DB-
BI_DA+
BI_DD+
BI_DD-
BI_DA-
BI_DC+
BI_DC-
-36
User's Manual of WGSW-24020/WGSW-48040

APPENDEX A