Sntp Server - Planet Networking & Communication WSGW-24020 User Manual

predefined unicast clients. To disable the polling for SNTP client, use the no form of this command.
Syntax
sntp unicast client poll
no sntp unicast client poll
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Global configuration mode
User Guidelines
Polling time is determined by the sntp client poll timer global configuration command.
Examples
The following example enables polling for the Simple Network Time Protocol (SNTP) predefined unicast clients.
console (config)# sntp unicast client poll

5.5.14 sntp server

The sntp server global configuration command configures the device to use the Simple Network Time Protocol (SNTP) to
request and accept Network Time Protocol (NTP) traffic from a server. To remove a server from the list of NTP servers, use the
no form of this command.
Syntax
sntp server ip-address | hostname [poll] [key keyid]
no sntp server host
ip-address — IP address of the server. An out-of-band IP address can be specified as described in the usage guidelines
hostname — Hostname of the server. (Range: 1 - 160 characters)
poll — Enable polling.
key keyed — Authentication key to use when sending packets to this peer. (Range:1 – 4294967295)
User's Manual of WGSW-24020/WGSW-48040
-18