Dot1X Timeout Tx-Period - Planet Networking & Communication WSGW-24020 User Manual

exchange, to 3600.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout quiet-period 3600

5.29.8 dot1x timeout tx-period

The dot1x timeout tx-period interface configuration command sets the number of seconds that the switch waits for a response
to an Extensible Authentication Protocol (EAP) - request/identity frame, from the client, before resending the request. Use the
no form of this command to return to the default setting.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds — Time in seconds that the switch should wait for a response to an EAP -request/identity frame from the client
before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet)
Examples
The following command sets the number of seconds that the switch waits for a response to an EAP - request/identity frame, to
3600 seconds.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout tx-period 3600
User's Manual of WGSW-24020/WGSW-48040
-35