Bridge Multicast Address - Planet Networking & Communication WSGW-24020 User Manual

Default Configuration
Disabled. All multicast addresses are flooded to all ports of the relevant VLAN.
Command Mode
Global Configuration mode
User Guidelines
If multicast routers exist on the VLAN and IGMP-snooping is not enabled, the bridge multicast forward-all command should
be used to enable forwarding all multicast packets to the multicast routers.
Example
In this example, bridge multicast filtering is enabled.
console (config)# bridge multicast filtering

5.4.3 bridge multicast address

The bridge multicast address interface configuration command registers MAC-layer multicast addresses to the bridge table,
and adds static ports to the group. To unregister the MAC address, use the no form of the bridge multicast address command.
Syntax
bridge multicast address {mac-multicast-address | ip-multicast-address}
bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove] {ethernet interface-list | port-channel
port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
add — Adds ports to the group. If no option is specified, this is the default option.
remove — Removes ports from the group.
mac-multicast-address — MAC multicast address.
ip- multicast-address — IP multicast address.
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen is used to designate a
range of ports.
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no spaces; a hyphen is used to
designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove, the command only registers the group in the bridge database. Static
User's Manual of WGSW-24020/WGSW-48040
-16