Planet Networking & Communication WSGW-24020 User Manual page 39

The Link Aggregation page contains the following fields:
LAG
Description
Admin Status
Type
Link Status
Speed
Duplex
Flow control
LAG Mode
Click the button for more detail port configuration.
Detail
Linkl Aggregation detail configuration
At per-LAG detail configuration page, the administrator can select ports to be the members of the LAG interface. The screen
Figure 4-11 Switch Link Aggregation screen
Indicates the number of the LAG interface. Up to eight LAG interfaces can be configured.
Indicates the description of the LAG ports.
Up indicates that the port is available and down shows administrator has taken the port offline.
after setup completed, please click the Save Settings option to save current setting.
The port types that comprise the LAG.
Shows an active connection when you choose the UP button, there is no active connection or
the port has been taken offline by an Admiinistrator when you choose the Down button.
Shows the connection speed on each port and the speed can be configured only when
auto-negotiation is disabled on that port.
The port duplex mode, Full (transmission occurs in both directions simultaneously) or Half
(transmission occurs in only one direction at a time). This mode can be configured only when
auto-negotiation is disabled and port speed is set to 10Mbps or 100Mbps.
Shows the flow control status of the port. It is active when the port runs at Full Duplex Mode.
Shows the current mode of the LAG interface.
User's Manual of WGSW-24020/WGSW-48040
-39-