Planet Networking & Communication WSGW-24020 User Manual page 79

24/48-port 10/100/1000mbps with 2/4 shared sfp managed ethernet switch
Table of Contents

Advertisement

Max Entries
Specifies the number of MAC addresses that can be learned on the port. The Max
Entries field is enabled only if Locked is selected in the Interface Status field. In
addition, the Limited Dynamic Lock mode is selected.
The default is 1.
Action on Violation
Where indicates the action to be applied to packets arriving on a locked port. The
possible field values are:
• Discard, which discards packets from any unlearned source. This is the
• Forward Normal, forwards packets from an unknown source without learning
• Discard Disable, which discards packets from any unlearned source and
Enable Trap
This enables traps when a packet is received on a locked port.
Trap Frequency
Which the amount of time (in seconds) between traps.
The default value is 10 seconds
In order to change the Learning Mode, the Lock Interface must be set to unlocked. Once the mode is
Notice
changed, the Lock Interface can be reinstated.
MAC addresses associated with the port. The port learns up to the maximum
addresses allowed on the port. Both relearning and aging MAC addresses are
enabled.
default value.
the MAC address.
shuts down the port. The port remains shut down until reactivated, or until the
device is reset.
-79-
User's Manual of WGSW-24020/WGSW-48040

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wsgw-48040

Table of Contents