Queue Setting - Planet Networking & Communication WSGW-24020 User Manual

CoS Default:
The Table contains the following fields:
Interface
Default CoS
Restore Defaults
LAG

4.8.2 Queue Setting

The Queue Setting screen (see figure 4-38) contains fields for defining the QoS queue forwarding types.
The page contains the following fields:
Strict Priority
WRR
Queue
WRR Weight
Interface to which the CoS configuration applies.
Determines the default CoS value for incoming packets for which a VLAN tag is not
defined. The possible field values are 0-7.
The default CoS is 0.
Restores the device factory defaults for mapping CoS values to forwarding queue.
LAG to which the CoS configuration applies.
Figure 4-38 Queue Setting screen
This indicates that traffic scheduling for the selected queue is based strictly on the
queue priority.
This indicates that traffic scheduling for the selected queue is based strictly on the
WRR.
Shows the queue for which the queue settings are displayed.
The possible field range is 1 - 4.
This displays the WRR weights to queues.
Default Rate 1:2:4:8
-84-
User's Manual of WGSW-24020/WGSW-48040