Negotiation; Flowcontrol - Planet Networking & Communication WSGW-24020 User Manual

5.7.7 negotiation

The negotiation interface configuration command enables auto-negotiation operation for the speed and duplex parameters of a
given interface. To disable negotiation, use the no form of this command.
Syntax
negotiation
no negotiation
Default Configuration
auto-negotiation
Command Mode
Interface Configuration (Ethernet, port-channel, out-of-band Ethernet) mode
User Guidelines
Turning off auto-negotiation on an aggregate link may, under some circumstances, make it non-operational. If the other side has
auto-negotiation turned on, it may re-synchronize all members of the aggregated link to half-duplex operation, and may, as per
the standards, set them all inactive.
Example
The following example enables autonegotiation on Ethernet e5.
Console(config)# interface ethernet e5
Console(config-if)# negotiation

5.7.8 flowcontrol

The flowcontrol interface configuration command configures the Flow Control on a given interface. To restore the default, use
the no form of this command.
Syntax
flowcontrol {auto | on | off | rx | tx}
no flowcontrol
auto—Enables auto-negotiation of Flow Control.
on—Enables Flow Control.
off—Disables Flow Control.
rx—Enables receiving pause frames only.
tx—Enables transmitting pause frames only
User's Manual of WGSW-24020/WGSW-48040
-19