Bridge Multicast Filtering - Planet Networking & Communication WSGW-24020 User Manual

specifying a MAC address deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent | delete-onreset |
delete-on-timeout | secure]
no bridge address [mac-address]
mac-address — A valid MAC address.
Interface — A valid Ethernet port.
port-channel-number — A valid port-channel number.
permanent — The address can only deleted by the no bridge address command.
delete-on-reset — The address is deleted after reset.
delete-on-timeout — The address is deleted after "age out" time has expired.
secure — The address is deleted after the port changes mode to unlock learning (no port security command). This
parameter is only available when the port is in learning locked mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on port e8 to the bridge
table.
console (config)# interface vlan 2
console (config-vlan)# bridge address 3aa2.64b3.a245 ethernet e8 permanent

5.4.2 bridge multicast filtering

The bridge multicast filtering global configuration command enables filtering of multicast addresses. To disable filtering of
multicast addresses, use the no form of the bridge multicast filtering command.
Syntax
bridge multicast filtering
no bridge multicast filtering
User's Manual of WGSW-24020/WGSW-48040
-15