Planet Networking & Communication WSGW-24020 User Manual page 239

Detailed — Detailed diagnostics.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
To test optical transceivers ensure a fiber link is present.
Examples
The following example displays the optical transceiver diagnostics.
console# show fiber-ports optical-transceiver
Port Temp Voltage
------ -------- ------------
g1 W
g2 OK
e3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
Data ready – Indicates transceiver has achieved power up and data is ready.
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
The following example displays detailed optical transceiver diagnostics
console# show fiber-ports transceiver detailed
Port Temp Voltage
[C]
Current
Power
------------
OK E
OK OK
Current
[Volt] [mA]
User's Manual of WGSW-24020/WGSW-48040
Output Input
Power Power
----------- ----------
OK OK
OK OK
Output Input
Power Power
-23
LOS
---------
OK
OK
LOS