Ports To Vlan - Planet Networking & Communication WSGW-24020 User Manual

Port Mode
Belongs to a single untagged VLAN
Access
Allowed to belongs to multiple untagged VLANs at
General
the same time
Allowed to belongs to multiple Tagged VLANs at
Trunk
the same time

4.4.3 Ports to VLAN

The Ports to VLAN screen contains fields for configuring ports to a VLAN. The port default VLAN ID (PVID) is configured on the
Create VLAN screen. All untagged packets arriving to the device are tagged by the ports PVID. The Ports to VLAN screen
contains a Port Table for VLAN parameters for each port. Ports are assigned VLAN membership by selecting and configuring
the presented configuration options, please refer to figure 4-16.
e
The page contains the following fields:
VLAN
Access
Trunk
General
Tagged
Untagged
Forbidden
Exclude
VLAN Membership
Figure 4-16 Ports to VLAN screen
Where means the VLAN number.
Indicates the port belongs to a single untagged VLAN. When a port is in Access
mode, the packet types which are accepted on the port cannot be designated.
Ingress filtering cannot be enabled/disabled on an access port.
Which indicates the port belongs to VLANs in which all ports are tagged, except for
one port that can be untagged.
Which indicates the port belongs to VLANs, and each VLAN is user-defined as
tagged or untagged (full 802.1Q mode).
Defines the interface as a tagged member of a VLAN. All packets forwarded by the
interface are tagged. The packets contain VLAN information.
Packets forwarded by the interface are untagged.
Forbidden ports are not included in the VLAN.
Excludes the interface from the VLAN. However, the interface can be added to the
VLAN through GVRP.
-44-
User's Manual of WGSW-24020/WGSW-48040
Frame Leave
Untagged
( Tag=PVID be removed)
Untagged
(Tag=PVID be removed)
Tagged
(Tag=PVID or Original VID be remained)