Planet Networking & Communication WSGW-24020 User Manual page 23

Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Switch. Ensure that the SFP transceiver is operating correctly.
4. Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media Converters, set the Link
mode to "1000 Force" is needed.
Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or through the management
interface of the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the MGB/MFB module to horizontal.
4. Pull out the module gently through the handle.
Never pull out the module without pull the handle or the push bolts on the module. Direct pull out the
Notice:
module with violent could damage the module and SFP module slot of the device.
Figure 2-8 Pull out the SFP transceiver
-23-
User's Manual of WGSW-24020/WGSW-48040