Library Entries; Table 2-6. Drive Configuration Selections - StorageTek L700 Service Manual

Operator Panel Entry
Table 2-5. Library/Network Configuration Record (Continued)
Port 0 Worldwide ID (library)
Subnet netmask address
Domain Name Service (DNS)
Dynamic Worldwide Name
Simplified Network Management
Protocol (SNMP)
Time
Web password

Table 2-6. Drive Configuration Selections

Drive #
Note: You cannot set any configuration data at the operator panel for T9x40

Library Entries

Four entries are required for a library—other entries will vary with your options:
1. Library SCSI ID or Fibre Channel Port 0 address
2. Drive Fast Load enable/disable
2-22
SCSI or On or
Fiber ID* Off Bus
drives running on Fibre Channel. You may, however, set an LTO
Fibre Channel drive's address to either a hard address of 0 or allow the
arbitrated loop ID to be set automatically.
Fourteenth Edition
StorageTek Proprietary
Not configurable: pre-set at the factory
Configured only if SNMP maps library
names to IP addresses
Configured to enable dynamic rather than
static names
Configured after general configuration is
completed; see Appendix B, "SNMP."
Drive # SCSI ID or
Fiber ID*
On or
Off Bus
95846