Replacement - StorageTek L700 Service Manual

11. Turn the drive tray over to access the four screws on the bottom of the drive tray. Using a Torx T-10
driver, remove the four drive screws.
12. Lift and remove the drive tray.
2

Replacement

1. Set the drive on a work surface, make sure the DRV cable is away from the drive so it does not get
pinched. Slide the drive tray over the drive so the SCSI and P2 cables do not get pinched.
2. On the left side of the drive, set the terminating power jumper to match the location of the drive
you removed.
3. Using a Torx T-10 driver, attach the four screws on the bottom of the drive tray.
2
95846
1. Drive tray bottom
2. Drive screw
1
E65223
1. Drive tray bottom
2. Drive screw
1
E65223
Fourteenth Edition
StorageTek Proprietary
Tape Drive Components
5-73